Introduction: The Foundation of Autonomous Driving
As vehicles move toward higher levels of autonomy (ADAS), the automotive camera module becomes one of the most critical sensors on the car. The Base de la cámara (Housing) is the chassis of this sensor—it holds the lens, optics, and PCB in precise alignment.
If this housing has a surface flaw, it can lead to module instability, improper focus, or seal failures. A “rough weld” might cause a leak; “damaged threads” might prevent proper assembly. Ensuring these bases are flawless is essential for the reliability of the entire vision system.
However, inspecting a camera base is geometrically complex. It’s not a flat sheet; it’s a 3D component with internal bores, threaded holes, rivet points, and multiple sidewalls. A single camera simply cannot see it all.
The Challenge: Internal Threads and Outer Walls
The project goal was comprehensive: Inspect all critical faces of the camera base.
This included a laundry list of hard-to-reach areas:
- Características internas: The internal threaded bore and bore edges.
- External Surfaces: Four outer sidewalls and the coded side.
- Puntos de reunión: Rivet-pressed surfaces and weld surfaces.
The defect list was equally demanding, requiring the detection of material underfill, blisters, peelingy específicamente thread damage (stripped threads/burrs), which are notoriously difficult to capture with standard lighting.
The camera base requires multi-face inspection, including internal threads and four outer sidewalls
The Solution: A 6-Camera Integrated Station
To capture every angle of this complex object, UnitX deployed a heavy-duty Automated Surface-Inspection System.
UnitX’s inspection station integrates 6 cameras to cover every critical angle of the camera housing
Configuración del sistema:
- Multi-View Imaging: Las características del sistema 6 integrado UnitX OptiX sistemas de visión distributed across dedicated stations. This allows for simultaneous inspection of the top, sides, and internal bores.
- Procesamiento de IA: A UnitX Corteza unit processes the feed from all 6 cameras, correlating defects across different views to ensure no double-counting or missed flaws.
- Integración de datos: Inspection results are communicated directly to the equipment layer, allowing for immediate process feedback.
Results: Speed Meets Precision
The system successfully automated what is typically a slow, manual rotation inspection process.
1. High-Speed Multi-Face Inspection
- Tiempo del ciclo: 2 segundos por pieza.
- In just two seconds, the system captures and analyzes images from 6 different cameras, inspecting threads, welds, and walls. This throughput matches high-volume automotive production lines.
2. Detecting the “Hard-to-See”
- Tasa de aceptación falsa: un 0.5%.
- The system reliably detects defects that often escape human notice, such as internal thread damage y hole opening damage.
3. Control de calidad confiable
- False Rejection Rate: ≤ 5%.
- By maintaining a low false rejection rate, the system ensures that good parts aren’t scrapped due to minor, non-functional surface variations (like harmless water stains vs. actual corrosion).
Defect Gallery
The images below showcase the system’s ability to peer inside bores and detect minute surface irregularities.
From damaged internal screw threads to subtle bulging, the UnitX AI identifies critical functional defects
Conclusión
In the production of ADAS components, precision is the only option. The Automotive Camera Module case study demonstrates UnitXsu capacidad para manejar geometrías 3D complejas. By utilizing a 6-camera setup driven by AI, we ensure that the housing protecting the car’s “eyes” is perfect—inside and out.
Need to inspect complex 3D parts?
Contacto UnitX to design a multi-camera solution for your product.
